Neuspeed 62.10.94 Manuel d'utilisateur télécharger pdf

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX

www.neuspeed.com

POWER PULLEY KIT

2014-UP Audi A3(8V) 1.8/2.0 TSI and 2015 VW GTI 2.0 TSI

PART # 62.10.94

INSTALLATION INSTRUCTIONS

PART LIST: 1 – CRANKSHAFT PULLEY 1 – BELT

1 – CRANKSHAFT BOLT

TOOLS REQUIRED: 1 – 16mm Wrench 1 – Ratchet Wrench

1 – T25 Torx 1 – VW Tool T10355 Counter Holder

1 – 24mm Socket 1 – Torque Wrench

1 – Long Handle Breaker Bar

NOTE: FACTORY TOOL REQUIRED AND PROFESSIONAL INSTALLATION RECOMMENDED.

1. Car Hoist required, vehicle not high enough from

ground with a jack or jack stands. NOTE: VW

GTI shown.

2. Remove passenger side wheel, then remove

lower engine splash guard. (8) T25 Torx screws.

3. Underneath bottom corner of bumper cap

remove the (2) T25 Torx screws.

4. Remove the lower half inner fender liner. (4)

T25 Torx screws.

5. Before removing ribbed belt, mark running

direction with marking pen if the stock belt and

pulley is ever to be re-installed.

6. Using a 16mm wrench, rotate idler pulley center

bolt upwards to release tension and remove

ribbed belt. Now slowly release belt tensioner.

7. Using the 24mm socket on crankshaft pulley

bolt, rotate engine clockwise to the “TDC”

position (Top Dead Center).

1 2

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX www.neuspeed.com POWER PULLEY KIT 2014-UP Audi A3(8V) 1.8/2.0

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX www.neuspeed.com 8. The notch on the pulley must line-u

Pas de commentaire

Neuspeed 62.10.94 Manuel d'utilisateur